LiftMaster SL930 SL930 Manual - Page 16
Button Control Wiring,
View all LiftMaster SL930 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
WIRING CONTROL WIRING BUTTON CONTROL WIRING One button, two button and three button controls may be connected individually or together as shown below. Most button controls have a common "buss bar" which connects the common terminals of all buttons together so that only one common wire needs to be run back to the gate operator control board. If this is not the case, the common terminals of each button may be connected together with wire. Connect the common terminal or terminals (COM) of the push button control to the Common (terminal 6) on the gate operator control board. Connect the Open button NO terminal of the push button control to Open (terminal 5) on the gate operator control board. Connect the Close button NO terminal of the push button control to Close (terminal 10) on the gate operator control board. If the stop button has normally closed contacts, connect the Stop button NC terminal to Stop (terminal 9) and remove the stop jumper that is on terminals 8 & 9. If the stop button has normally open contacts, connect the Stop button terminal NO to the NO Stop (terminal 11) on the gate operator control board. If more than one push button control is used on one gate operator, connect wires from the Open, Close and Common in parallel to the control board. If the stop button has normally closed, contacts connect the stop buttons in series to the control board. If the stop buttons have normally open contacts, connect the stop buttons in parallel to NO Stop (terminal 11) on the control board. Figure 6 Stop Jumper NOTE: Remove stop jumper only if the stop button has normally closed contacts and connect stop buttons in series as shown. If the stop buttons have normally open contacts, do not remove the stop jumper and connect stop buttons in parallel to terminal 11 (M/S stop) and terminal 6 (Common). Stop Jumper 16