Linksys NSS2000 Cisco NSS2000 Series Network Storage System Administration Gui - Page 158
LAN LED (Front Panel), Hard Disk Drive LEDs (Front Panel), To reset the box, Reset, Power, Solid Green
UPC - 745883577088
View all Linksys NSS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Troubleshooting A • To reset the box: Press and hold the Reset button while the system is running until the Power LED begins to blink green. Release the Reset button. LAN LED (Front Panel) Solid Green: The LAN link is up and running at 1000 link speed, but is currently idle. Flickering Green: The LAN link is up and running at 1000 link speed and is currently active. The LED flickers off with activity. Solid Yellow: The LAN link is up and running at 10/100 link speed, but is currently idle. Flickering Yellow: The LAN link is up and running at 10/100 link speed and is currently active. The LED flickers off with activity. Off: No LAN link is detected. Hard Disk Drive LEDs (Front Panel) The ACT and Error LEDs associated with each of the installed disk drives indicate disk-drive activity, or an error condition. The various states of the ACT LED indicates the drive activity: • Solid Green: The disk drive is configured but is currently idle. • Flicker Green: The disk drive is configured, active, and not rebuilding. Flickers off with activity. • Blinking Green: The disk drive is configured and a RAID array is currently rebuilding to the disk drive. • Off: The disk drive is not configured (not part of a RAID or JBOD array and not exported). The various states of the Error LED indicate that the disk drive is in an error condition: • Solid Red: The disk drive is in a failed state. • Blinking Red: The disk drive is predicated to fail (via S.M.A.R.T.). We recommend that you replace the disk drive to avoid the loss of data. • Off: The drive is OK. Cisco Small Business NSS2000 Series Administration Guide 150