Linksys NSS4100 Cisco NSS4000 and NSS6000 Series Network Storage System Admini - Page 171
All CIFS Connections were Unexpectedly Ended, Hotplugging the Ethernet Link doesn’t Reset IP or Link
![]() |
UPC - 745883578818
View all Linksys NSS4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
Troubleshooting All CIFS Connections were Unexpectedly Ended A All CIFS Connections were Unexpectedly Ended If all current CIFS connections to the NSS were unexpectedly severed, check to see if the the hostname the Network Identification page was changed. Changing the hostname severs any current CIFS connections to the NSS. To resolve the problem, change the name back to the original hostname. Hotplugging the Ethernet Link doesn't Reset IP or Link Rate When you disconnect the Ethernet link and reconnect it, the IP address and link rate does not reset. For example, if you unplug a cable from the NSS to a 100 Mbps switch and then reconnect the NSS to a 1 Gps switch, the link is not restored. To resolve the problem: STEP 1 Unplug the Ethernet link. STEP 2 Wait at least 15 seconds. STEP 3 Reconnect the link. STEP 4 Wait 10 seconds. The link is re-established. You can view the status from the System Status page on the configuration interface. Unable to Create a Share or Quota for a Volume When you attempt to create a share, the volume does not appear in the Location field. When you try to create a quota, the quota is not successfully added for the volume. The problem is likely caused by the volume being locked. An encrypted volume is automatically locked whenever the NSS is rebooted or is manually locked through the configuration interface. As long as the volume is locked, you cannot use the volume to create shares or quotas (you can however, set up the Home Directory). Linksys Small Business NSS4000 and NSS6000 Series Network Storage System Administration Guide 163
![](/manual_guide/products/linksys-nss6100-cisco-nss4000-nss6000-series-network-storage-administration-guide-69796a6/171.png)