Linksys NSS4100 Cisco NSS4000 and NSS6000 Series Network Storage System Admini - Page 25
Viewing the Network Settings, Network Device Settings, Manager Menu, Network, Assign Via, Manual
UPC - 745883578818
View all Linksys NSS4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Adding the NSS to your Network Viewing the Network Settings 3 Viewing the Network Settings The Network Device Settings page displays information about the physical and virtual interfaces currently configured on the NSS. NOTE If you hotplug the Ethernet link after the initial installation of the NSS, make sure you that you wait 15 seconds between the time you unplug the cable and then plug it back in. The NSS displays the correct new settings within 10 seconds. To display the Network Device Settings page, from the Manager Menu, click Network IP. The Network Device Settings table displays the following: • Link: "1+ 2" appears in this column. • VLAN: The ID assigned to the virtual interface. For physical interfaces, this column is blank. • Assign Via: The method used to assign an IP configuration to the physical or virtual interface. Options include: • DHCP: The IP configuration was assigned by a DHCP server. • Manual: A static IP configuration was manually entered through the NSS configuration interface. • AutoIP: The interface was configured to use DHCP for IP configuration but no DHCP server was found. Instead the IP address was assigned by the AutoIP protocol. Linksys Small Business NSS4000 and NSS6000 Series Network Storage System Administration Guide 17