Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 11

Mounting the display unit - how to use

Get Lowrance Elite-4x DSI PDF manuals and user guides View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Display unit Mounting the display unit Before mounting the display unit mount, make sure there is nothing in the area that will obstruct the display unit when it is installed on the bracket. To install bracket mount: 1. Place the bracket on the desired mounting surface and mark the four mounting holes. If you want to run the unit's cables up through the mounting surface, make a mark in the center of the bracket mounting surface. 2. Drill pilot holes for the four mounting holes. If desired, use a 1-inch (25mm) bit to drill the center cabling hole in the mounting surface. 3. If you are running the cables up through the mounting surface, push the cables through the mounting surface and then pull them through the cabling hole in the center of the bracket. 4. Align the mounting bracket with the four mounting holes and use the supplied screws to fasten it to the mounting surface. 5. Connect the display unit to the bracket mount. 11 0.TWEETY INSTALL_SONAR_DSI.indd 11 9/14/2011 11:55:35 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
Display unit
11
Mounting the display unit
Before mounting the display unit mount, make sure there is nothing in the area that will obstruct the
display unit when it is installed on the bracket.
To install bracket mount:
1.
Place the bracket on the desired mounting surface and mark the four mounting holes. If
you want to run the unit’s cables up through the mounting surface, make a mark in the
center of the bracket mounting surface.
2.
Drill pilot holes for the four mounting holes. If
desired, use a 1-inch (25mm) bit to drill the
center cabling hole in the mounting surface.
3.
If you are running the cables up through the mounting surface, push the cables through the
mounting surface and then pull them through the cabling hole in the center of the bracket.
4.
Align the mounting bracket with the four mounting holes and use the supplied screws to
fasten it to the mounting surface.
5.
Connect the display unit to the bracket mount.
0.TWEETY INSTALL_SONAR_DSI.indd
11
9/14/2011
11:55:35 PM