Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 15
Selecting transducer location, Aligning transducer ratchets
View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
DSI Sonar Good location Poor angle Poor location Too high Aligning transducer ratchets Ratchets are used to ensure the transducer is installed parallel to the ground. 1. Insert the ratchets in the bracket with the letter "A" aligned with the dot stamped on the outside of the transducer bracket. 2. Slide the transducer into the bracket and temporarily slide the bolt through the transducer bracket. CD Selecting transducer location The DSI transducer must be in the water at all times and in a location that has a smooth flow of water A when the boat is moving. B If it is not placed in a smooth flow of water, interference from bubbles and turbulence may E diminish product performance. The unit also could lose bottom signal when the boat is on plane. Install the transducer at least 1' (.3m) away from the engine's lower unit. 15 0.TWEETY INSTALL_SONAR_DSI.indd 15 9/14/2011 11:55:41 PM