Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 4
D. Attaching Transducer to Transom, Routing cables, E. Make, test run to determine results - installation
View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Traditional Sonar D. Attaching Transducer to Transom 1. Adjust the transducer so its face is parallel with the ground and its center line is even with the bottom of the boat hull. 2. Hold the transducer and bracket assembly against the transom. When the transducer and bracket are properly aligned mark its position on the hull. 3. Drill the mounting holes for the transducer bracket. Use a #29 bit (for the #10 screws). Transom Run the cable over the bolt and through the bracket. Do not over tighten the lock nut; otherwise transducer may not kick- up if it strikes an object. Routing cables When mounting your transducer, make sure to leave some slack in the cable near the transducer. If you need to drill a hole in the transom to pass the connector through, the hole size will depend on the connector on the end of the transducer's cable. Transducer face must be parallel with the ground Bottom of hull E. Make test run to determine results After the transducer is installed make a test run to ensure the transducer is installed properly. Use the 4 0.TWEETY INSTALL_SONAR_DSI.indd 4 9/14/2011 11:55:31 PM