Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 3

C. Assembling the bracket - sonar

Page 3 highlights

Traditional Sonar 3. Hold the transducer Align dot and assembly against letter "A". the transom. Look at dot the transducer from A the side. If it is par- allel to the ground, then the "A" position is correct. 4. If the transducer can not be adjusted so its face is parallel to the ground, remove the transducer and ratchets from the bracket. Reinsert the ratchets into the bracket, this time with the letter "B" aligned with the dot stamped in the bracket. Reassemble the transducer and bracket and place it against the transom. 5. Check to see if the transducer will adjust so its face is parallel with the ground. Repeat this process until the transducer can be adjusted so its face is parallel with the ground. C. Assembling the bracket After determining the correct position for the ratchets, loosely assemble the transducer and bracket assembly. Lock nut Metal washer Metal washer Bolt Rubber washers Ratchets 3 0.TWEETY INSTALL_SONAR_DSI.indd 3 9/14/2011 11:55:31 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22

3
Traditional Sonar
3. Hold the transducer
assembly
against
the transom. Look at
the transducer from
the side. If it is par-
allel to the ground,
then the “A” position
is correct.
4. If the transducer can not be adjusted
so its face is parallel to the ground, re-
move the transducer and ratchets from
the bracket. Reinsert the ratchets into
the bracket, this time with the letter “B”
aligned with the dot stamped in the
bracket. Reassemble the transducer
and bracket and place it against the
transom.
5.
Check to see if the transducer will ad-
just so its face is parallel with the ground.
Repeat this process until the transducer can
be
adjusted so its face is parallel with the
ground.
C. Assembling the bracket
After determining the correct position for the
ratchets, loosely assemble the transducer and
bracket assembly.
Lock nut
Metal washer
Rubber washers
Ratchets
Metal washer
Bolt
Align dot and
letter "A".
dot
A
0.TWEETY INSTALL_SONAR_DSI.indd
3
9/14/2011
11:55:31 PM