Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 5

slots in the transducer mounting bracket to loosen the screws and slide the transducer up or down, if adjustments are necessary. Traditional Sonar Transducer epoxied to hull Transducer Epoxy Shoot-thru-hull Skimmer and Pod transducer installation Before attempting any installation on boats with flotation material sandwiched within the hull, consult the boat manufacturer. In a shoot-thru-hull installation the transducer is epoxied to the inside of the boat hull. Hull Keel pad keel pad that offers a good transducer mounting surface. Make sure the Skimmer transducer is oriented so the nose of the transducer is facing the bow (front) of the boat. If the transducer has a built in temp sensor, it will only show the temperature of the hull, not the water temp. WARNING: Do not remove material from the inner hull. Careless grinding on the hull could damage hull integrity. Contact the boat dealer or manufacturer Before you epoxy the transducer to the hull, make sure the area is clean, dry and free of oil or grease. The surface of the hull must be flat so the entire to confirm hull specifications. On vee hulls A transducer can not shoot through wood or metal hulls. Wood and metal hulls require either a transom mount or thru-hull installation. For shootthru-hull applications many boat hulls have a flat 5 try to place the transducer where the dead rise is 10° or less. 0.TWEETY INSTALL_SONAR_DSI.indd 5 9/14/2011 11:55:31 PM