Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 2
Traditional Sonar - transducer
View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Traditional Sonar A. Select a transducer location To function properly the Skimmer transducer must be in the water at all times and in a location that has a smooth flow of water when the boat is moving. If the transducer is not placed in a smooth flow of water, interference caused by bubbles and turbulence may show on-screen as random lines or dots. The unit also could lose bottom signal when the boat is on plane. NOTE: Mount the transducer at least one foot away from the engine lower unit. B. Aligning Ratchets on bracket You will use the ratchets to ensure the transducer is installed parallel to the ground. 1. Insert the ratchets in the bracket with the letter "A" aligned with the dot stamped on the outside of the transducer bracket. 2 Good locations Too high Poor angle Poor locations 2. Slide the transducer into the bracket and temporarily slide the bolt through the transducer bracket. Ratchet Bracket 0.TWEETY INSTALL_SONAR_DSI.indd 2 9/14/2011 11:55:30 PM