Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 7
Trolling motor Skimmer and, Pod Installation - trolling motor bracket
View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Traditional Sonar 6. When finished, the face of the transducer should be parallel with the hull with a minimum amount of epoxy between the hull and transducer. Trolling motor Skimmer and Pod Installation The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is available through LEI Extras at www.lei-extras.com. The TMB-S bracket is used to attach a one-piece bracket skimmer transducer to a trolling motor. The Pod transducer does not need a TMB-S trolling motor bracket to be installed on a trolling motor. It only needs a hose clamp (adjustable strap). The top of the Pod transducer is curved to fit the contour of the trolling motor, so you do not need a TMB-S mounting bracket. Installing transducer on trolling motor: 1. Attach the skimmer transducer to the bracket as shown in the diagram. Internal tooth washer Bolt Plastic bracket Lock nut Flat washer 2. S lide the adjustable strap (hose clamp) through the plastic bracket on the skimmer transducer or through the Pod transducer slots and then slip the strap around the trolling motor. Position the transducer to so its face is pointing straight down when the trolling motor is in the water. 7 0.TWEETY INSTALL_SONAR_DSI.indd 7 9/14/2011 11:55:32 PM