Lowrance Elite-4x DSI Sonar and DSI Installation Manual - Page 16
Mounting to transom
View all Lowrance Elite-4x DSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
DSI Sonar 3. Hold the transducer assembly against the transom. Look at the transducer from the side. If it is parallel to the ground, then the "A" position is correct. 4. If the transducer can not be adjusted so its face is parallel to the ground, remove the transducer and ratchets from the bracket. Reinsert the ratchets into the bracket, this time with the letter "B" aligned with the dot stamped in the bracket. Reassemble the transducer and bracket and place it against the transom. 5. Repeat this process until the transducer can be adjusted so its face is parallel with the ground. 2. Hold the transducer and bracket assembly against the transom. When the transducer and bracket are properly aligned mark its position on the hull. Mounting to transom 1. Adjust the transducer so its face is parallel with the ground and its center is even with the bottom of the boat hull. 16 0.TWEETY INSTALL_SONAR_DSI.indd 16 9/14/2011 11:55:42 PM