Lowrance LMF-400 Installation and Operation Manual - Page 43
EP Configuration &, Calibration
![]() |
View all Lowrance LMF-400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Section 4: EP Configuration & Calibration To configure items connected to the LowranceNET, press MENU, select SYSTEM SETUP and press ENTER. Highlight BUS DEVICES and press ENTER to open the Bus Devices list. Bus Devices works as the device manager for the bus, allowing you to configure and unconfigure devices and set and reset critical values such as alarms and calibration. NOTE: The Suzuki Engine Interface, EP-35 Temperature sensor, EP-15 Fluid Level, EP-50 Storage Device and EP-10 Fuel Flow are the only sensors that can be configured through the Bus Devices list. Bus Devices highlighted in the System Setup menu (left). Searching Bus Devices window (center) with Bus Devices list (right). EP-35 Temperature Configuration The EP-35 Temperature sensor has three configuration options: Inside, Outisde and Water. An unconfigured temperature sensor will appear on the bus devices list as UnCfg Temp. To configure EP-35 Temp Sensor: 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. 2. Highlight BUS DEVICES and press ENTER. The Bus Devices list will appear. 3. Select an unconfigured temp sensor (UNCFG TEMP) and press ENTER. The following message will appear: Press Enter to Configure Temp Sensor. 4. Press ENTER, which will open the Sel Temp menu with three options: Water Temp, Outside Temp and Inside Temp. 5. Highlight the desired option and press ENTER. The temp is now configured. You will be directed to the Bus Devices list. Press EXIT repeatedly to get back to the main display. 37
![](/manual_guide/products/lowrance-lmf400-installation-operation-manual-605bc66/43.png)