Lowrance LMF-400 Installation and Operation Manual - Page 63
To execute 5-Point calibration, Reset Calibration, To Reset Calibration
View all Lowrance LMF-400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
To execute 5-Point calibration: 1. Before following the steps below, make sure your fuel tank is empty. Press MENU, use the up and down keys to select SYSTEM SETUP and press ENTER. 2. Highlight BUS DEVICES and press ENTER. Choose the fluid level you want to calibrate and press ENTER. Select CALIBRATE and press ENTER. The Number of Points menu will appear with three options: 2, 3 and 5. Select 5, for three-point calibration, and press ENTER. 3. The Levels menu will appear with five options: Empty Level, 1 Qtr Level, Half Level, 3 Qtr Level and Full level. Select EMPTY LEVEL and press ENTER. The following message will appear: Set Tank to Empty Level Press Enter. 4. Press ENTER. You will be taken back to the Levels menu. Add 1quarter tank of fuel. (If you have a 100 gallon tank, add 25 gallons of fuel.) 5. Highlight 1 QTR LEVEL and press ENTER. The following message will appear: Set Tank to 1 Qtr Level Press Enter. 6. Press ENTER. You will be taken back to the Levels menu. Fill your tank up halfway. (If you have a 100 gallon tank, add another 25 gallons of fuel.) 7. Highlight HALF LEVEL and press ENTER. The following message will appear: Set Tank to Half Level Press Enter. Press ENTER. You will be taken back to the Levels menu. 8. Fill your tank to the 3 quarter level. (If you have a 100 gallon tank, add another 25 gallons of fuel.) Highlight 3 QTR LEVEL and press ENTER. The following message will appear: Set Tank to 3 Qtr Level Press Enter. 9. Press ENTER. You will be taken back to the Levels menu. Fill up your tank, then select FULL LEVEL and press ENTER. The following message will appear: Set Tank to Full Level Press Enter. 10. Press ENTER. You will be taken back to the Levels menu. Press EXIT repeatedly to get back to the main display. Reset Calibration The Reset Calibration command allows you to reset a fuel flow back to factory default settings. You will only need to reset calibration when you believe your fuel flow has been calibrated incorrectly. To Reset Calibration: 1. Press MENU, select SYSTEM SETUP and press ENTER. 2. Highlight BUS DEVICES and press ENTER. Select the fluid level you want to reset and press ENTER. 57