MSI 970A User Guide - Page 4

Preface, Voir La Notice D'installation Avant De Raccorder Au Reseau., Ms-7693

Page 4 highlights

Preface FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the measures listed below. ◯ Reorient or relocate the receiving antenna. ◯ Increase the separation between the equipment and receiver. ◯ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ◯ Consult the dealer or an experienced radio/television technician for help. Notice 1 The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2 Shielded interface cables and A.C. power cord, if any, must be used in order to comply with the emission limits. VOIR LA NOTICE D'INSTALLATION AVANT DE RACCORDER AU RESEAU. Micro-Star International MS-7693 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. CE Conformity Hereby, Micro-Star International CO., LTD declares that this device is in compliance with the essential safety requirements and other relevant provisions set out in the European Directive. iv

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80

±v
Preface
CE Conform±ty
Hereby, M±cro-Star Internat±onal CO., LTD declares that th±s dev±ce ±s
±n compl±ance w±th the essent±al safety requ±rements and other relevant
prov±s±ons set out ±n the European D±rect±ve.
FCC-B Rad±o Frequency Interference Statement
Th±s equ±pment has been tested and found to comply w±th the l±m±ts for a Class B d±g±tal
dev±ce, pursuant to Part 15 of the FCC Rules. These l±m±ts are des±gned to prov±de
reasonable protect±on aga±nst harmful ±nterference ±n a res±dent±al ±nstallat±on. Th±s
equ±pment generates, uses and can rad±ate rad±o frequency energy and, ±f not ±nstalled
and used ±n accordance w±th the ±nstruct±ons, may cause harmful ±nterference to rad±o
commun±cat±ons. However, there ±s no guarantee that ±nterference w±ll not occur ±n a
part±cular ±nstallat±on. If th±s equ±pment does cause harmful ±nterference to rad±o or
telev±s±on recept±on, wh±ch can be determ±ned by turn±ng the equ±pment off and on, the
user ±s encouraged to try to correct the ±nterference by one or more of the measures
l±sted below.
Reor±ent or relocate the rece±v±ng antenna.
Increase the separat±on between the equ±pment and rece±ver.
Connect the equ±pment ±nto an outlet on a c±rcu±t d±fferent from that to wh±ch the
rece±ver ±s connected.
Consult the dealer or an exper±enced rad±o/telev±s±on techn±c±an for help.
Not±ce 1
The changes or mod±ficat±ons not expressly approved by the party respons±ble for
compl±ance could vo±d the user’s author±ty to operate the equ±pment.
Not±ce 2
Sh±elded ±nterface cables and A.C. power cord, ±f any, must be used ±n order to comply
w±th the em±ss±on l±m±ts.
VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.
Th±s dev±ce compl±es w±th Part 15 of the FCC Rules. Operat±on ±s subject to the follow±ng
two cond±t±ons:
th±s dev±ce may not cause harmful ±nterference, and
th±s dev±ce must accept any ±nterference rece±ved, ±nclud±ng ±nterference that may
cause undes±red operat±on.
1)
2)
M±cro-Star Internat±onal
MS-7693