Makita LS1016 Technical Reference - Page 24
] ADJUSTMENT, 4]-3. Guide fence, epair, 4]-4. Blade
![]() |
View all Makita LS1016 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
P 24/ 37 Repair [4] ADJUSTMENT [4]-3. Guide fence 1) Pretighten M8x25 Hex socket head bolt (with flat washer and spring washer) at the threaded hole designated with gray arrow. The round shape around the thread hole is smaller than the others (designated with black arrow) for M8x25 Hex socket head bolts. 2) Do fine adjustment of the right angle between Blade and Guide fence using 1R208. 3) Tighten M8x25 Hex socket head bolt (4pcs.) in order 1, 2, 3, and 4. without moving any parts. (Fig. 73) Fig. 73 Pretighten M8x25 Hex socket head bolt 1 2 3 4 Guide plate 1R208 Blade [4]-4. Blade Use 1R208 and M8x20 Hex socket head bolt on Arm holder complete to adjust 90 degree angle between Blade and Turn base. (Fig. 74) Use 1R207 and M8x20 Hex socket head bolts on the right side and the left side of Arm complete to adjust 45 degree angle between Blade and Turn base. (Fig. 75) Note: When tilting the carriage to the right, tilt the carriage to the left slightly after loosening the lever and press Release button. Tilting the carriage to the left can be done without pushing Release button. Adjust Maximum cutting depth as follows; 1) Lower Stopper lever to position Blade as shown in Fig. 76. 2) Push the carriage toward Guide fence fully and lower Handle completely. (Fig. 76) 3) Use the hex end of 782232-8 to turn M8x20 Hex socket head bolt until the periphery of Blade extends slightly below the top surface of Turn base and adjust Blade so that the tip is placed as illustrated in Fig. 77. Fig. 74 Fig. 75 M8x20 Hex socket head bolt for 90 degree angle adjusting Release button Arm complete Arm holder complete Fig. 76 M8x20 Hex socket head bolt on Blade case complete Carriage (gray portion) Fig. 77 Stopper lever Hex end 782232-8 M8x20 Hex socket head bolt for 45 degree angle adjusting 255mm Blade tip 4mm 260mm Blade tip Triangle mark Triangle mark on Kerf board on Kerf board
![](/manual_guide/products/makita-ls1016-technical-reference-d8582fe/24.png)