Marantz SR7005 SR7005 User Manual - English - Page 12
Set up the remote control unit - best settings
View all Marantz SR7005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ENGLISH DEUTSCH FRANÇAIS Set up speakers (Audyssey® Auto Setup) ITALIANO ESPAÑOL NEDERLANDS SVENSKA About setup microphone placement • Measurements are performed by placing the setup microphone successively at multiple positions throughout the entire listening area, as shown in GExample qH. For best results, we recommend you measure in six or more positions, as shown in the illustration (up to eight positions). • Even if the listening environment is small as shown in GExample wH, measuring at multiple points throughout the listening environment results in more effective correction. GExample qH FL SW C FR GExample wH FL SW C FR 1 Prepare the setup microphone Mount the setup microphone on a tripod or stand and place it in the main listening position. When placing the setup microphone, adjust the height of the sound receptor to the level of the listener's ear. Sound receptor Setup microphone ( : Measuring positions) ( : Measuring positions) SL *M SBL SBR FL Front speaker (L) FR Front speaker (R) C Center speaker SW Subwoofer SR SL *M SR SBL SBR SL Surround speaker (L) SR Surround speaker (R) SBL Surround back speaker (L) SBR Surround back speaker (R) NOTE • Do not hold the setup microphone in your hand during measurements. • Avoid placing the setup microphone close to a seat back or wall as sound reflections may give inaccurate results. About the main listening position (*M) The main listening position is the position where listeners would normally sit or where one would normally sit alone within the listening environment. Before starting Audyssey Auto Setup, place the setup microphone in the main listening position. Audyssey MultEQ® XT uses the measurements from this position to calculate speaker distance, level, polarity, and the optimum crossover value for the subwoofer. 2 Set up the subwoofer If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below. nn When using a subwoofer with a direct mode Set the direct mode to "On" and disable the volume adjustment and crossover frequency setting. nn When using a subwoofer without a direct mode Make the following settings: • Volume : "12 o'clock position" • Crossover frequency : "Maximum/Highest Frequency" • Low pass filter : "Off" • Standby mode : "Off" NOTE When you use two subwoofers, please adjust the subwoofer volume controls individually so that each subwoofer level is as close as possible to 75 dB using the test tone (vpage 81) before Audyssey Auto Setup. 3 Set up the remote control unit nn Set up the operation mode Press AMP to set the remote control unit to amplifier operation mode. Press AMP 8 The "Simple version" section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back speakers. For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 50 .