Maytag MFI2266AES Service Manual - Page 70
before, Water Filter, Filter Status Indicator Light, Temperature Controls
View all Maytag MFI2266AES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Troubleshooting Ice and Water PROBLEM Refrigerator is leaking water POSSIBLE CAUSES • Plastic tubing was used to complete water connection. • Improper water valve was installed. Water flow is • Water pressure is low. slower than normal • Improper water valve was installed. • Copper tubing has kinks. • Water filter is clogged or needs to be changed. Ice storage bin will not close • Ice cube blockage Water filter indicator light is red • Water filter needs to be replaced. • Filter indicator sensor needs to be reset. Ice forms in inlet tube to ice maker • Water pressure is too low • Saddle valve not open completely. • Freezer temperature is too high. WHAT TO DO • The manufacturer recommends using copper tubing for installation. Plastic is less durable and can cause leakage. The manufacturer is not responsible for property damage due to improper installation or water connection. • Check water connection procedure (see pages 8-9). Self-piercing and 3⁄16" saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection. • Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters. • Check water connection procedure in your Installation Instructions. Self-piercing and 3⁄16" saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection. Open water valve completely and check for leaks. • Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing. • Change water filter (see page 14). • Remove spilled ice cube(s) before replacing ice storage bin. • If filter is not available, replace with bypass filter. See Water Filter, pages 14-15. • See Filter Status Indicator Light, page 10. • Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters. • Open saddle valve completely. • See Temperature Controls, pages 10 and 11. Freezer temperature should be between 0° to 2° F (-18° to -17° C) to produce ice. 29