Miele Triflex HX2 Operating instructions/Installation instructions - Page 174
es if the vacuum cleaner is
View all Miele Triflex HX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
en-US Push the PowerUnit connector down on to the suction wand from above until it audibly clicks into place (right image detail). Press the release catch to separate the individual sections from each other (Fig. 06). Inserting the battery (Fig. 07) Push the battery along the guide lines until it audibly clicks into place in the PowerUnit. If you want to separate the sections again, press both release catches at the side of the battery to remove the battery (Fig. 08). Connecting the Electrobrush (Fig. 09) Depending on how you decide to configure your vacuum cleaner, you can connect either the PowerUnit connector or the suction wand connector to the Electrobrush. Insert the connector down into the Electrobrush from above until it audibly clicks into place. To separate the individual sections from each other, press the release catch on the Electrobrush and pull the connector out of the Electrobrush (Fig. 10). General battery information The rechargeable battery is supplied not fully charged. Charge the battery completely before using it for the first time. Allow approximately 4 hours for this. To activate the battery, it is essential to place it in the PowerUnit when charging it for the first time. 174 Once the battery is fully charged, the battery charging state indicator on the PowerUnit switches off to conserve energy. The maximum charging capacity is only achieved once the battery has been charged and run down five times. A full charge provides enough power for 14 minutes if the vacuum cleaner is used at the maximum power level in its fully assembled state. However, if you use the PowerUnit solo and select the minimum power level, you can vacuum for up to 60 minutes at a time. Charging the battery (without wall mounting) (Fig. 11) You can store the vacuum cleaner upright and charge the battery directly. Before charging the battery for the first time, you must read the information in "Installation and connection" - "General battery information". Connect the PowerUnit to the Electrobrush to provide a secure base for the vacuum cleaner. Swing the vacuum cleaner forward until the Electrobrush connector audibly clicks into place. Plug the supplied charging cable into the charging socket on the bottom of the battery. Plug the charger into a power socket. The charging process will start.