NEC MT860 User Manual - Page 27

Setting the function switch There are two switches on the bottom of the battery case: an applicable projector selector switch (1) and laser enable/disable switch (2). Check the projector being used and decide whether to enable or disable laser, then set these switches as necessary using the tip of a thin ball-point pen. On this model, an applicable projector selector switch (1) is not used. OFF ON Switch (2) On: Enabled (the laser lights when the LASER button is pressed) [Factory default] Off: Disabled (the laser does not light even when the LASER button is pressed) Disable the laser when using in an environment in which the unit is accessible to children. Turning off the Projector To turn off the projector: First press the POWER (ON/STAND BY) button on the projector cabinet or the POWER OFF button on the remote control for a minimum of two seconds. The power indicator will glow orange. After the projector turns off, the cooling fans keep operating for 90 seconds (Coolingoff time). Second, turn off the Main Power switch. The power indicator will go out. Last unplug the power cable. CAUTION Do not unplug the power cable from the wall outlet or do not turn off the main power under any one of the following circumstances. Doing so can cause damage to the projector: • While the Hour Glass icon appears. • While the message "Please wait a mo- ment." appears. This message will be displayed after the projector is turned off. • While the cooling fans are running. (The cooling fans continue to work for 90 seconds after the projector is turned off). • While accessing a PC card. (The PC Card Access indicator lights.) OFF VIDEO POWER RGB ON VIEWER AUTO ADJ. LASER ASPECT FREEZE 3D REFORM HELP POINTER PIC-MUTE VOLUME MAGNIFY SLIDE ZOOM FOCUS FOLDER SLIDE LIST E-23