NEC MT860 User Manual - Page 64

PC Control Codes and Cable Connection PC Control Codes Function Code Data POWER ON 02H 00H 00H 00H 00H 02H POWER OFF 02H 01H 00H 00H 00H 03H INPUT SELECT RGB 1 02H 03H 00H 00H 02H 01H 01H 09H INPUT SELECT RGB 2 02H 03H 00H 00H 02H 01H 02H 0AH INPUT SELECT VIDEO 02H 03H 00H 00H 02H 01H 06H 0EH INPUT SELECT S-VIDEO 02H 03H 00H 00H 02H 01H 0BH 13H INPUT SELECT DVI (DIGITAL)* 02H 03H 00H 00H 02H 01H 1AH 22H INPUT SELECT VIEWER 02H 03H 00H 00H 02H 01H 1FH 27H PICTURE MUTE ON 02H 10H 00H 00H 00H 12H PICTURE MUTE OFF 02H 11H 00H 00H 00H 13H SOUND MUTE ON 02H 12H 00H 00H 00H 14H SOUND MUTE OFF 02H 13H 00H 00H 00H 15H ON SCREEN MUTE ON 02H 14H 00H 00H 00H 16H ON SCREEN MUTE OFF 02H 15H 00H 00H 00H 17H NOTE: Contact your local dealer for a full list of PC Control Codes if needed. NOTE: The DVI connector is not available on MT860. Cable Connection Communication Protocol Baud rate 38400 bps Data length 8 bits Parity No parity Stop bit One bit X on/off None Communications procedure . Full duplex Using Software Keyboard 1 to 0 and Characters Use to type in IP address or projector name SP Inserts a space BS Deletes one character backward Returns to the previous Advances to the next OK Executes the selection Cancel Cancels the selection Drag bar Use to move the software keyboard on the screen. MODE Selects one of three modes for alphabet and special characters. NOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs. PC Control Connector (D-SUB 9P) To TxD of PC To RxD of PC To GND of PC 12345 6789 To RTS of PC To CTS of PC NOTE: Pins 1, 4, 6 and 9 are no used. NOTE: Jumper "Request to Send" and "Clear to Send" together on both ends of the cable to simplify cable connection. E-60