NEC NP-PX2201UL User Manual - Page 26
not grip and hold the projector, sure you have at least four
View all NEC NP-PX2201UL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Rear Remote Sensor (→ page 11) Exhaust vent Heated aiir is exhausted from here. (→ page xviii, 73) Terminals (→ page 8) 1. Introduction Controls (→ page 7) Main power switch While AC power is being supplied, set the main power switch to ON position (|), then your projector will enter a standby state. Power Cord Stopper (→ page 14) AC IN terminal Connect the supplied power cord's three-pin plug here, and plug the other end into an active wall outlet. (→ page 13) Handle (located on 4 positions) For transportation NOTE: • For moving the projector, make sure you have at least four people. At the same time, do not grip and hold the projector other than by these handles. Attempting to move the projector with less than four people could result in back pain or other injuries. 6