Netgear DGN1000 DGN1000 Setup Manual - Page 7

You can use the LEDs to verify various conditions.Table 1 describes each LED. Table 1. LED Descriptions Label Power LED Activity Solid Green Solid Red Off Factory reset LAN Ports 1 - 4 Solid Green Blinking Green Off Description Power is supplied to the router. POST (Power-On Self-Test) failure or device malfunction Power is not supplied to the router Lights momentarily when the reset button is pressed for 6 seconds, then blinks red three times when released. It then turns green as the gateway resets to the factory defaults. The Local port has detected an Ethernet link with a device. Data is being transmitted or received. No link is detected on this port. DSL Solid Green Blinking Green Off Internet Port Solid Green Wireless WPS Solid Red Blinking Green Off Solid Green Blinking Green Off Solid Green Blinking Green Off The ADSL port is synchronized with an ISP's network-access device. Indicates ADSL training-ADSL is synchronizing with the DSLAM. The unit is off or there is no IP connection. There is an Internet session. If the session is dropped due to an idle timeout, and an ADSL connection is still present, the light will remain green. If the session is dropped for any other reason, the light will turn off. IP connection failed (no DHCP or PPoE response, PPPoE authentication failed, etc.) Data is being transmitted over the ADSL port. No Internet connection detected or device in bridged mode. Indicates that the Wireless port is initialized. Data is being transmitted or received over the wireless link. The Wireless Access Point is turned off. Indicates that wireless security has been enabled. WPS-capable device is connecting to the device. WPS has not been set or enabled. Getting to Know Your Wireless Router 3