Netgear M4100-26G Software Administration Manual - Page 198

ProSafe M4100 and M7100 Managed Switches command to enable traffic shaping by specifying the maximum transmission bandwidth limit for all interfaces (Global Config) or for a single interface (Interface Config). The value is a percentage that ranges from 0 to 100 in increments of 5. The default bandwidth value is 0, meaning no upper limit is enforced, which allows the interface to transmit up to its maximum line rate. The bw value is independent of any per-queue maximum bandwidth values in effect for the interface and should be considered as a second-level transmission rate control mechanism that regulates the output of the entire interface regardless of which queues originate the outbound traffic. CLI: Configure traffic-shape (Netgear Switch) (Config)#traffic-shape? Enter the shaping bandwidth percentage from 0 to 100 in increments of 5. (Netgear Switch) (Config)#traffic-shape 70? Press Enter to execute the command. (Netgear Switch) (Config)#traffic-shape 70 (Netgear Switch) (Config)# Web Interface: Configure Traffic Shaping 1. Set the shaping bandwidth percentage to 70 percent. a. Select QoS > CoS > Advanced > CoS Interface Configuration. A screen similar to the following displays. b. Under CoS Interface Configuration, scroll down and select the interface 1/0/3 check box. Now 1/0/3 appears in the Interface field at the top. c. In the Interface Shaping Rate (0 to 100) field, enter 70. 198 | Chapter 11. CoS Queuing