Netgear M4100-26G Software Administration Manual - Page 549

ProSafe M4100 and M7100 Managed Switches are used to configure captive portal. VSAs are denoted in the ID column and are comma delimited (vendor ID, attribute ID). Table 3. RADIUS Attributes for Configuring Captive Portal Users RADIUS Attribute No. Description Range Usage User-Name 1 User name to be authorized. 1-32 characters Required User-Password 2 User password. 8-64 characters Required Session-Timeout 27 Logout once session timeout is reached (seconds). If the attribute is 0 or not present then use the value configured for the captive portal. Integer (seconds) Optional Idle-Timeout 28 Log out once idle timeout is reached (seconds). If the attribute is 0 or not present, then use the value configured for the captive portal. Integer (seconds) Optional WISPr-Max-Band width-Up 14122, 7 Maximum client transmit rate (b/s). Integer Limits the bandwidth at which the client can send data into the network. If the attribute is 0 or not present, then use the value configured for the captive portal. Optional WISPr-Max-Band width-Down 14122, 8 Maximum client receive rate (b/s). Limits the bandwidth at which the client can receive data from the network. If the attribute is 0 or not present, then use the value configured for the captive portal. Integer Optional Default None None 0 0 0 0 CLI: Configure RADIUS as the Verification Mode (Netgear Switch) (Config-CP 1)#radius-auth-server Default-RADIUS-Server (Netgear Switch) (Config-CP 1)#verification radius Web Interface: Configure RADIUS as the Verification Mode 1. Select Security > Control > Captive Portal > CP Configuration. Chapter 32. Captive Portal | 549