Netgear M4100-26G Software Administration Manual - Page 66

ProSafe M4100 and M7100 Managed Switches The Route Configuration screen displays. 2. In the Route Type list, select DefaultRoute. 3. In the Next Hop IP Address field, enter one of the routing interface's IP addresses. • The Network Address and Subnet Mask fields will not accept input as they are not needed. • The Preference field is optional. A value of 1 (highest) will be assigned by default if not specified. 4. Click the Add button on the bottom of the screen. This creates the default route entry in the routing table. Add a Static Route When the switch performs IP routing, it forwards the packet to the default route for a destination that is not in the same subnet as the source address. However, you can set a path (static route) that is different than the default route if you prefer. The following procedure shows how to add a static route to the switch routing table. CLI: Add a Static Route The following commands assume that the switch already has a defined a routing interface with a network address of 10.10.10.0, and is configured so that all packets destined for network 10.10.100.0 take the path of routing port. (FSM7328S) #show ip route Total Number of Routes 1 Network Subnet Next Hop Next Hop AddressMaskProtocolIntfIP Address 10.10.10.0 255.255.255.0 Local 1/0/3 10.10.10.1 66 | Chapter 4. Port Routing