Netgear M4100-26G Software Administration Manual - Page 366

ProSafe M4100 and M7100 Managed Switches CLI: Renumber Stack Members Note: When issuing a command (such as move management, or renumber), NETGEAR recommends that you wait until the command has fully executed before issuing the next command. For example, if a reset is issued to a stack member, use the show port command to verify that the switch has re-merged with the stack, and all ports are joined before issuing the next command. • If specific numbering is required, NETGEAR recommends that you assign stack members their numbers when they are first installed and configured in the stack, if possible. • If the stack unit number for a switch is unused, you can renumber the unit by using the switch renumber CLI command. This command is found in global config mode. • If the newunit-id has been preconfigured, you might need to remove the newunit-id from the configuration before renumbering the unit. • If you need to reassign multiple existing stack unit numbers, the configuration could become mismatched. To avoid this situation, NETGEAR recommends that you power down all switches except the master, and then add them back one at a time using the procedure in Section Add Switches to an Operating Stack on page 361. Web Interface: Renumber Stack Members 1. Renumber the stacking member's ID from 3 to 2. a. Select System > Management > Basic > Stack Configuration. A screen similar to the following displays. b. Under Stack Configuration, scroll down and select the Unit ID 3 check box. c. In the Unit ID list, select 2. d. Click Apply. 366 | Chapter 19. Switch Stacks