Netgear M4100-26G Software Administration Manual - Page 399

ProSafe M4100 and M7100 Managed Switches The following example shows how to configure the NETGEAR switch shown in the preceding figure to add a double VLAN tag for traffic going from the subnet domain connected to port 1/0/24. This example assumes there is a Layer 2 switch connecting all these devices in your domain. The Layer 2 switch tags the packet going to the NETGEAR switch port 1/0/24. The example is shown as CLI commands and as a Web interface procedure. CLI: Enable a Double VLAN Create a VLAN 200. (Netgear Switch)#vlan database (Netgear Switch) (Vlan)#vlan 200 (Netgear Switch) (Vlan)#exit Add interface 1/0/24 to VLAN 200, add pvid 200 to port. (Netgear Switch) #config (Netgear Switch) (Config)#interface 1/0/24 (Netgear Switch) (Interface 1/0/24)#vlan pvid 200 (Netgear Switch) (Interface 1/0/24)#vlan participation include 200 (Netgear Switch) (Interface 1/0/24)#exit Add interface 1/0/48 to the VLAN 200 in a tagging mode. (Netgear Switch) (Config)#interface 1/0/48 (Netgear Switch) (Interface 1/0/48)#vlan participation include 200 (Netgear Switch) (Interface 1/0/48)#vlan tagging 200 (Netgear Switch) (Interface 1/0/48)#exit Select interface 1/0/48 as the provider port. (Netgear Switch) (Config)# (Netgear Switch) (Config)#interface 1/0/48 (Netgear Switch) (Interface 1/0/48)#mode dvlan-tunnel (Netgear Switch) (Interface 1/0/48)#exit Web Interface: Enable a Double VLAN 1. Create static VLAN 200: Chapter 24. Double VLANs and Private VLAN Groups | 399