Netgear M4100-26G Software Administration Manual - Page 365
Renumber Stack Members, member <unit-id> <switchindex>, show supported switchtype
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 365 highlights
ProSafe M4100 and M7100 Managed Switches 1. Issue the member command. To view the supported unit types, use the show supported switchtype command. 2. Next, configure the unit you just defined with configuration commands, just as if the unit were physically present. Ports for the preconfigured unit come up in a detached state. 3. To see the ports, use the show port all command. Now you can configure the detached ports for VLAN membership and any other port-specific configuration. After you preconfigure a unit type for a specific unit number, attaching a unit with different unit type for this unit number causes the switch to report an error. The show switch command indicates config mismatch for the new unit and the ports on that unit don't come up. To resolve this situation, you can change the unit number of the mismatched unit or delete the preconfigured unit type using the no member command. When you add a preconfigured switch to the switch stack, the stack applies either the preconfigured configuration or the default configuration. The following table lists the events that occur when the switch stack compares the preconfigured configuration with the new switch. Table 2. Preconfigured Switches Compared to Stack Configuration Switch Type Is the Same Yes Yes Stack Member Number Result Is the same. The switch stack applies configuration to the preconfigured new switch and adds it to the stack. Does not match. • The switch stack applies its default stack member number to the preconfigured switch and adds it to the stack. • The stack member number configuration in the preconfigured switch changes to reflect the new information. Is not found in the stack configuration. • The switch stack applies the default configuration to the new switch and adds it to the stack. • The preconfigured information is changed to reflect the new information. Is not found in the preconfigured switch. The switch stack applies the default configuration to the preconfigured switch and adds it to the stack. Renumber Stack Members This example is provided as CLI commands and a Web interface procedure. Chapter 19. Switch Stacks | 365