Netgear WBC502 Hardware Installation Guide - Page 10
on any cables., cables so that they cannot be stepped on or tripped over. Be sure that nothing rests
View all Netgear WBC502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Insight Instant AirBridge WBC502 Hardware Installation Guide • If applicable to your device, the peripheral power cables are equipped with three-prong plugs to help ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable. If you must use an extension cable, use a three-wire cable with properly grounded plugs. • Observe extension cable and power strip ratings. Make sure that the total ampere rating of all products plugged into the extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the extension cable or power strip. • To help protect your system from sudden, transient increases and decreases in electrical power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS). • Position system cables, power adapter cables, or power cables carefully. Route cables so that they cannot be stepped on or tripped over. Be sure that nothing rests on any cables. • Do not modify power adapters, power adapter cables, power cables or plugs. Consult a licensed electrician or your power company for site modifications. • Always follow your local and national wiring rules. Failure to follow these guidelines can result in damage to your NETGEAR product, which might not be covered by NETGEAR's warranty, to the extent permissible by applicable law. Introduction 10 Hardware Installation Guide