Netgear WC7500 User Manual - Page 198
Click the tab for the profile group for which you want to con RF management.
View all Netgear WC7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
ProSAFE Wireless Controller 5. Click the tab for the profile group for which you want to configure RF management. 6. Configure the settings as described in the following table. Setting Description TX Power Settings Default Tx Power Make a selection from the menu to specify how the transmission (Tx) power is configured on the access points: Full, Half, Quarter, Eighth, or Minimum. By default, the selection from the menu is Half. When automatic Tx power control is enabled, the selection from the menu is used as the initial power level for the access points. Automatic Tx Power Control Select the enable radio button to enable automatic Tx power control: • When a client attempts to connect to an access point at low power, the access point's Tx power is automatically increased above the default level. • When coverage areas overlap, the access point's Tx power is automatically decreased below default level. By default, automatic Tx power control is enabled. Select the disable radio button to disable automatic Tx power control. WLAN Healing Maximum Neighbors to Participate in Self-healing From the menu, select the maximum number of neighboring access points that increase or decrease power to cover for a failing access point. Selecting 0 (zero) disables this feature. Use close neighbors, not a distant access point, and do not use all access points. By default, the selection from the menu is 3. Configure WiFi and QoS Settings 198