Netgear WGX102 WGX102v2 Reference Manual - Page 17
The Label on the Rear Panel of the WGX102, The WGX102 Bottom Panel, Unique device Passcode PWD - wall plugged wireless range extender
View all Netgear WGX102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102 The Label on the Rear Panel of the WGX102 The label on the rear panel of the WGX102 contains the items listed below. • MAC address • Model number • Serial number • Unique device Passcode (PWD) The WGX102 Bottom Panel The factory default reset push button is located on the bottom panel of the WGX102, as shown below. Figure 2-2: WGX102 Underside Use a fine pen point or an unfolded paper clip to push in the reset button. If you press the reset button for less than 15 seconds, the WGX102 does a soft reset, similar to unplugging and then plugging the device in again. When you press the reset button for 15 seconds or more, the WGX102 resets to the factory defaults, as described in "Restoring the Default WGX102 Configuration and Password" on page 8-7. Introduction 2-5 202-10042-02 v1.1