Netgear WNDR4700 Installation Guide - Page 6
Table 1. - firmware
View all Netgear WNDR4700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Table 1. LEDs LED Description Power • Solid amber. The router is starting up. • Blinking amber. The firmware is upgrading, or the Restore Factory Settings button was pressed. • Solid green. The router is ready. • Blinking green. The firmware is corrupted. See www.netgear.com/support. • Off. Power is not supplied to the router. Internet • Solid green. The Internet connection is ready. • Solid amber. The Ethernet cable connection to the modem has been detected. • Off. No Ethernet cable is connected to the modem. Wireless • Solid blue. The wireless radio is operating in either 2.4 GHz or 5 GHz mode. • Blinking. The router is in WPS mode. • Off. The wireless radios are off for both 2.4 GHz and 5 GHz. USB • Solid blue: The router has accepted the USB device. The USB device is ready to be used. • Blinking blue. A USB HDD is plugged in and is trying to connect. • Off: No USB device is connected, someone clicked the Safely Remove Hardware button, and it is now safe to remove the attached USB device. HDD • Solid green: The internal HDD is working fine; • Solid green plus red: The HDD is 85% full. • Blinking green: Someone pressed the Backup button; the SD card data is being copied to the internal HDD. • Blinking green and red: The HDD is 95% full. • Solid red: The HDD is not formatted, the HDD connection is loose, or there is a failure alert. • Off: No internal HDD is connected. 4