Nikon 25040 User Manual - Page 108
Connections, Nikon View, displays a Module has no sources error when
UPC - 018208250400
View all Nikon 25040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Nikon View displays a "Module has no sources" error when you attempt to display the camera's data files on your computer Checklist: • Is the camera correctly connected to the computer? Connect the camera to your computer's serial port or SCSI chain as described in "Connections." If you are using an SCSI connection, be sure that the device number you have chosen for the camera is not the same as that assigned other SCSI devices, that ON has been chosen as the camera's TERMINATOR setting, and that one of the devices in the chain is providing termination power. If you are using a notebook computer, check its documentation to determine whether it requires an additional external terminator at the computer's end of the SCSI chain. In the event that you are using a serial connection, check to be sure that the data transfer rate you have chosen is supported by your computer, and that the computer's port settings are "8-bit, no parity, one stop bit." • Is Nikon View properly installed on your computer? Consult the documentation provided with the software. 94 Troubleshooting : General Problems