Nikon 25040 User Manual - Page 91
Connections, Making a Serial Port Connection
![]() |
UPC - 018208250400
View all Nikon 25040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Connections This chapter describes how to set up your camera to communicate with a computer and how to connect your camera to a computer by means of the serial cables provided in this package or the SCSI cable available separately as part of the SCSI Kit. Before you can use your camera with a computer, you will need to install the Nikon View software package provided with this product. For information on using Nikon View software to view the contents of your camera's memory or to transfer recordings to disk for long-term storage, refer to the Nikon View User's Manual. Note: Although the COOLPIX 300 comes equipped with both serial and SCSI interfaces, only one can be used at a time. You cannot connect the camera simultaneously to two computers or to two ports on a single computer. If you wish to change the connection, you will first have to turn the camera and computer off, disconnect the cable, and then reconnect the devices using one of the methods described in the following sections. Making a Serial Port Connection This section describes how to adjust your camera's serial-port settings and how to connect your camera to a computer using the serial cable provided with the COOLPIX 300. Connections : Making a Serial Port Connection 77
![](/manual_guide/products/nikon-25040-user-manual-e1ed8d9/91.png)