Nikon 25040 User Manual - Page 96
Caution, CANCEL, camera off, wait four or five seconds before turning it on again.
![]() |
UPC - 018208250400
View all Nikon 25040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Caution: Choosing a SCSI ID that has been assigned to another device will prevent communication between the COOLPIX 300 and your computer and could result in loss of data from your hard disk. Be sure that the number you choose for the COOLPIX 300 is not already assigned to another SCSI device. Once you have chosen an SCSI ID for the COOLPIX 300, use the stylus to choose a setting for the camera's built-in terminator. Because the COOLPIX 300 has only one SCSI connector, the camera will be the last item in the SCSI chain. In most circumstances, therefore, the terminator should be set to ON. Note: You will need to turn the camera off and then on again before any changes to the SCSI settings will be put into effect. After turning the camera off, wait four or five seconds before turning it on again. Once the camera has been turned back on, the new SCSI ID will be displayed in square brackets next to ID in the window shown above. To discard any changes and return to the setup menu, press CANCEL. 82 Connections : Making a SCSI Connection
![](/manual_guide/products/nikon-25040-user-manual-e1ed8d9/96.png)