Onkyo TX-RZ70 TX RZ Manual - En - Page 133

2. Speaker „ 1. Configuration Change the settings of connection environment of the speakers. • If the settings for "Speaker Channels", "Subwoofer", "Height 1 Speaker", or "Height 2 Speaker" have been changed, the Dirac Live ( →p166, p170) measurement results are deleted. ‰ Speaker Channels (Default Value: 7.1.4 ch) Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1 ch", "7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", "5.1.2 ch", "6.1.2 ch", "7.1.2 ch", "4.1.4 ch", "5.1.4 ch", "6.1.4 ch" or "7.1.4 ch" to suit the number of speaker channels connected. ‰ Subwoofer (Default Value: 2 ch) Set whether a powered subwoofer is connected or not. No When a powered subwoofer is not connected 1 ch When 1 powered subwoofer is connected 2 ch When 2 powered subwoofers are connected Setup ‰ Height 1 Speaker (Default Value: Top Front) Set the speaker type if height speakers are connected to the HEIGHT 1 terminals. Select "Top Middle", "Top Rear", "Rear High", "Dolby Speaker (Front)", "Dolby Speaker (Surr)", "Dolby Speaker (Back)", "Front High" or "Top Front" according to the type and layout of the connected speakers. • The setting cannot be selected if "Bi-Amp" is set to "Front/Center". • When two sets of height speakers are being used, "Top Rear", "Rear High", "Dolby Speaker (Surr)", and "Dolby Speaker (Back)" cannot be selected. • "Dolby Speaker (Surr)" and "Dolby Speaker (Back)" can only be selected when surround speakers or surround back speakers are being used, respectively. You can check speakers that you are using on the figure displayed in "Speaker Channels". • If an item cannot be selected even though connection is correct, check that the settings in "Speaker Channels" matches the number of connected channels. 133