Onkyo TX-RZ70 TX RZ Manual - En - Page 72
Connecting an Integrated Amplifier (ZONE 2), Multi-zone, Playing Back ZONE 2
![]() |
View all Onkyo TX-RZ70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Connecting an Integrated Amplifier (ZONE 2) Connections You can enjoy 2 ch audio in the separate room (ZONE 2) while performing playback in the main room (where this unit is located). Use an analog audio cable to connect the ZONE 2 PRE/LINE OUT jacks on this unit to the input jack on an integrated amplifier in the separate room. • To output audio from an externally connected AV component to ZONE 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV components can be output to ZONE 2 only when the audio is analog or 2 ch PCM signal. When the AV component is connected to this unit with a digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output. Setup • Settings are required to output audio to ZONE 2. Press on the remote controller, and set "Speaker" - "Configuration" - "Zone 2 Preout" ( →p134) to "Zone 2". • When connecting an integrated amplifier that does not have a volume control, set "Multi Zone" - "Zone 2" - "Output Level" ( →p158) to "Variable" (Default Value: Fixed) on the Setup menu. If you do not set this, the volume output a Input will be very loud and there is a danger of damage to the integrated amplifier, Terminal speakers, etc. When connecting an integrated amplifier that has a volume control, leave this as "Fixed". Integrated amplifier a Analog audio cable Multi-zone ( →p107) Playing Back (ZONE 2) ( →p108) 72
![](/manual_guide/products/onkyo-txrz70-tx-rz-manual-en-a42f1c0/72.png)