Onkyo TX-RZ70 TX RZ Manual - En - Page 134
Height 2 Speaker Default Value: Top Rear, Zone Speaker Default Value: No
View all Onkyo TX-RZ70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
2. Speaker Height 2 Speaker (Default Value: Top Rear) Set the speaker type if height speakers are connected to the HEIGHT 2 terminals. Select "Front High", "Top Front", "Top Middle", "Top Rear", "Rear High", "Dolby Speaker (Front)", "Dolby Speaker (Surr)" or "Dolby Speaker (Back)" according to the type and layout of the connected speakers. However, the options selectable for the "Height 1 Speaker" are as follows. - If "Height 1 Speaker" is set to "Front High": Select from "Top Middle", "Top Rear", "Rear High", "Dolby Speaker (Surr)" or "Dolby Speaker (Back)". - If "Height 1 Speaker" is set to "Top Front" or "Dolby Speaker (Front)": Select from "Top Rear", "Rear High", "Dolby Speaker (Surr)" or "Dolby Speaker (Back)". - If "Height 1 Speaker" is set to "Top Middle": Fixed to "Rear High". • "Dolby Speaker (Surr)" and "Dolby Speaker (Back)" can only be selected when surround speakers or surround back speakers are being used, respectively. You can check speakers that you are using on the figure displayed in "Speaker Channels". • If an item cannot be selected even though connection is correct, check that the settings in "Speaker Channels" matches the number of connected channels. Zone Speaker (Default Value: No) Set whether ZONE 2 speakers and ZONE 3 speakers are being used. • This setting cannot be selected when "Zone 2 Preout" is set to "Zone B". No When neither ZONE 2 speakers nor ZONE 3 speakers are used Zone 2 When ZONE 2 speakers are used Zone 2/Zone 3 When both ZONE 2 speakers and ZONE 3 speakers are used • This cannot be selected when 2 sets of height speakers are used. Setup Zone 2 Preout (Default Value: Zone 2) Set an output destination of the audio output from ZONE 2 PRE/LINE OUT/ ZONE B LINE OUT jack. • This setting is fixed to "Zone 2" when "Zone Speaker" is set to "Zone 2" or "Zone 2/Zone 3". Zone 2 Zone B When connecting an integrated amplifier in a separate room (ZONE 2) When connecting an integrated amplifier, transmitter of wireless headphones, etc. to ZONE B Bi-Amp (Default Value: No) Set whether the speakers are bi-amp connected. • You cannot select a setting other than "No" or "Front" when using ZONE speakers. No Front Front/Center When no speakers are bi-amp connected When only front speakers are bi-amp connected • This setting cannot be selected under the following conditions. - "Speaker Channels" is set to "6.1.4 ch" or "7.1.4 ch" - "Speaker Channels" is set to "6.1.2 ch", "7.1.2 ch", "4.1.4 ch", or "5.1.4 ch" and "Zone Speaker" is set to "Zone 2" or "Zone 2/Zone 3" - "Speaker Channels" is set to "6.1 ch", "7.1 ch", or "2.1.2 ch" to "5.1.2 ch" and "Zone Speaker" is set to "Zone 2/Zone 3" When front speakers and the center speaker are bi-amp connected This can only be selected when you have set "Speaker Channels" to "3.1 ch", "5.1 ch", or "7.1 ch". 134