Onkyo TX-RZ70 TX RZ Manual - En - Page 206

General Specifications Appendix Amplifier Section Rated Output Power Maximum Effective Output Power THD+N (Total Harmonic Distortion + Noise) Input Sensitivity and Impedance Rated RCA Output Level and Impedance Phono Maximum Input Signal Voltage Frequency Response Tone Control Characteristics Signal to Noise Ratio Supported impedance of Speakers Headphone Rated Output Supported impedance of Headphones Headphones Frequency Response North American and Taiwanese models European, Australian and Asian models (North American models) With 8 ohm loads, both channels driven, from 20 Hz20 kHz; rated 140 watts per channel minimum RMS power, with no more than 0.08% total harmonic distortion from 250 milliwatts to rated output. (FTC) (Taiwanese models) 11 ch × 210 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC) 11 ch × 210 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC) (North American models) 250 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD 11 ch × 250 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD (JEITA) 0.08% (20 Hz - 20,000 Hz, Rated output power) 200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM) PRE OUT : 1 V/470 Ω PRE OUT (ZONE 2) : 1 V/2.2 kΩ LINE OUT (ZONE 2, ZONE B): 200 mV/2.2 kΩ LINE OUT (ZONE 3) : 200 mV/470 Ω 70 mV (MM 1 kHz 0.5%) 10 Hz - 100 kHz/+1 dB, -3 dB (Direct) MAIN : ±10 dB, 20 Hz (Bass), ±10 dB, 20 kHz (Treble) ZONE 2 : ±10 dB, 100 Hz (Bass), ±10 dB, 10 kHz (Treble) ZONE 3 : ±10 dB, 100 Hz (Bass), ±10 dB, 10 kHz (Treble) 107 dB (IHF-A, LINE IN, SP OUT), 78 dB (IHF-A, PHONO IN, SP OUT) 4 Ω - 16 Ω 75 mW + 75 mW (32 Ω, 1 kHz, 10% THD) 8 Ω - 600 Ω 10 Hz - 100 kHz 206