Panasonic AG-UX90 AG-UX90 Operating Instructions - Page 68

≥ It is not possible to adjust the gain value using the GAIN button and jog dial in the following situations: j During Freeze Frame (l 87) ≥ If the gain value is increased, the noise on the screen increases. ≥ In Auto Iris Mode or Auto Shutter Mode, the screen brightness may not change even if you adjust the gain. (l 65, 70) ≥ When a negative gain value (a value between -3 dB and -1 dB) is selected, if you set [EXTENDED SENSITIVITY] to [OFF], the gain value will be set to 0 dB. ∫ Changing the maximum possible gain value for Auto Gain Mode Select the menu. MENU : [AUTO SW] # [AGC LIMIT] # desired setting [3 dB]/[6 dB]/[9 dB]/[12 dB]/[15 dB]/[18 dB]/[21 dB]/[24 dB]/[27 dB]/[30 dB] ≥ Separate [AGC LIMIT] settings can be stored for the following [REC FORMAT] settings, which differ in size (picture size): (l 148) j [REC FORMAT] settings with a size indicated as UHD (3840k2160) j [REC FORMAT] settings with a picture size of 1920k1080 or below Super Gain You can use Super Gain by registering [SUPER GAIN] to a USER button. Super Gain allows you to set the gain value to 33 dB or 36 dB. ≥ Please refer to page 80 for details about setting the USER button. ≥ Switch to Manual Mode. (l 45) Press the USER button to which [SUPER GAIN] is registered or touch the applicable USER button icon. ≥ To cancel Super gain, press the USER button or touch the USER button icon again. ∫ To change the gain value of Super Gain Select the menu. MENU : [SW SETUP] # [SUPER GAIN] # desired setting [33 dB]/[36 dB] ≥ Super Gain is not available in the following cases: j In Auto Gain Mode j During Freeze Frame (l 87) - 68 -