Panasonic PT-EZ570U Operating Instructions - Page 20
Preparation, ON/OFF switch, Wired remote jack
View all Panasonic PT-EZ570U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
About Your Projector (14) (22) (15) (23) (16) (17) (18) (24) (19) (25) (26) (20)* Preparation (21) (27) (14) button D isplay the Eco management function. (Æpage 44) (15) button O perate the P-timer function. (Æpage 44) (16) button P auses the projected image and sound tentatively. (Æpage 44) (25) button Adjust the focus. (Æpage 46) (26) button Operate the information function. (Æpage 46) (27) Wired remote jack C onnect the M3 stereo mini-jack cable (not supplied) to this jack when using as a wired remote control. (17) button Correct keystone distortion. (Æpage 45) (18) button Select the Lens Shift function. (Æpage 44) (19) button Zoom in and out the images. (Æpage 46) (20) button O perate the Picture in Picture function. (Æpage 46) *Only for EZ570 series, EW630 series and EW530 series. (21) ON/OFF switch W hen using the remote control, set this switch to "ON". Set it to "OFF" for power saving when it is not in use. (22) button Select a screen mode. (Æpage 44) (23) button S elect the Digital zoom +/- mode and resize the image. (Æpage 44) (24) Input Selection buttons: , , Select an input source (Input 1 - Input 3). Attention zzDo not drop the remote control. zzAvoid contact with liquids. zzDo not attempt to modify or disassemble the remote control. Note zzThe remote control can be used within a distance of about 5 m (16.4 ft) if pointed directly at the remote control signal receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced. zzIf there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly. zzYou can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light caused by the properties of the screen. zzWhen the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set the projector as far from the luminous source as possible. 20 - ENGLISH