Panasonic PT-EZ570U Operating Instructions - Page 68
Power management, Standby mode, Direct on, P-timer
View all Panasonic PT-EZ570U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Setting Power management For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period. 1111 Press ▲▼ to select [Power management]. 2222 Press ► or the button to access the submenu. JJMode 1111 Press ▲▼ and then press the button to select one mode among the items as below. Ready Shut down Off When the lamp has been fully cooled down, the indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the side control or remote control is pressed. When the lamp has been fully cooled down, the power will be turned off. [Power management] function is off. JJTimer 1111 Press ▲▼ to select [Timer] and then press the button. 2222 Press ▲▼ to set the Timer(1~30min). Standby mode This function can set the electric power when the projector is standing by. 1111 Press ▲▼ to select [Standby mode] and then press the button. 2222 Press ▲▼ to switch between the items as below. Normal Eco Network The normal situation. The power less than 0.5W. The power less than Normal. Note zzWhen selecting [Network], the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off. zzIf [Standby mode] is set to [Eco], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-232C protocol commands. zzIf set to [Network], you can use network functions when the projector is standing by. Direct on 1111 Press ▲▼ to select [Direct on] and then press the button. 2222 Press ▲▼ to switch between [On] and [Off]. zzWhen this function is set to [On], the projector will be automatically turned on just by connecting the AC power cord to a wall outlet. zzBe sure to turn off the projector properly. If the projector is turned off in the incorrect sequence, the [Direct On] function does not work properly. P-timer This function allows you to change the setting of the P-timer and execute it. 1111 Press ▲▼ to select [P-timer]. 2222 Press ► or button to access the submenu. JJMode 1111 Press ▲▼ button to select one mode among the items as below. Count up The P-timer display 000:00 appears on the screen and the count up starts (000:00-180:00). The time set in the Timer setting Count down appears on the screen and the countdown starts. JJTimer 1111 Press ▲▼ to select [Timer] and then press the button. 2222 Press▲▼ to set the [Timer](1-180 Min). zz[Timer] is available in [Count down] only. Factory default value is 10 Min. Settings 68 - ENGLISH