Panasonic PT-EZ570U Operating Instructions - Page 65

Setting Attention zzBe sure to note the new Logo PIN code and keep it on hand. If you lost the number, you could no longer change the Logo PIN code setting. Picture in Picture This function is used to project two images simultaneously by placing a separate small sub screen within or next to the main screen. 1111 Press ▲▼ to select [Picture in Picture*]. zzYou can also press the button on the remote control for more than 3 seconds to display [Picture in Picture] menu. 2222 Press the button to access the submenu. zzOnly the sound from the source of Main picture is valid, while the source of Sub picture cannot output the sound. *(Only for EZ570 series, EW630 series and EW530 series.) JJUser setting Show the selected mode ([Off/User 1-5]) and its status ([Stored /Free/ Adj.]). [User 1] and [User 2] have stored default values. JJP in P/P by P P IN P P by P Provide the images of Main picture and Sub picture at the ratio of Screen aspect in the Screen Menu. Provide the images of Main picture and Sub picture at the ratio of 4:3. Note zzIn [P in P] the larger picture is main picture, and the smaller one is sub picture; in [P by P], the left picture is main picture, and the right one is sub picture. JJMain picture/ Sub picture 1111 Press to adjust the display position of active frame indicated in white. zzThe frame will disappear after 10 seconds or when the button is pressed. Input Source Size Position Select an input from Input 1-3. Select an input source. Select the display size. Press the button at Position and the display position setting screen appears. zzSelecting the Main picture or the Sub picture D uring Picture in Picture mode, and being undisplayed On Screen Menu, press the button to select Main or Sub picture. (A red frame will be displayed on the selected picture.) zzSwitching Input and Source W hen selecting Main picture or Sub picture, input and source can be set by pressing the button on the side control or INPUT 1/2/3 button on the remote control. Operation on the On Screen Menu is not necessary. JJFrame lock Set the Frame Lock to Main picture or Sub picture. JJReset Press the button at [Reset] to display a confirmation box. To reset, press the button at [Yes]. JJMode free Delete the data stored in the Mode and return to [Free]. Use the ▲▼ buttons to select [Mode free] and press the button to show the [Where to free?] dialog box. Move the highlight to one of the mode ([User 1 - 5]) which you want to delete and press the button. Then the confirmation box appears. To delete, select [Yes]. JJStore Store the adjusted data in the [User 1-5]. Use the ▲▼ buttons to select [Store] and press the button to show the [Where to store?] dialog box. Move the highlight to one of the mode (User 1 - 5) which you want to store and press the button. Then the confirmation box appears. To store adjusted data, select [Yes]. Note zzThe [Picture in Picture] function is not available depending on the input signals and the selected input terminals. zzWhen the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture. Settings ENGLISH - 65