Panasonic SABT330 SABT230 User Guide - Page 7

Getting started Main unit (Front) e.g., [BT730] 12 3 45 POWER iPod VOLUME OPEN/CLOSE Pull open. SD CARD SETUP MIC SELECTOR 6 7 1 Standby/on switch (POWER Í/I) (> 19) Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still consuming a small amount of power. 2 Power indicator The indicator lights when this unit is turned on. 3 Connect iPod/iPhone (> 32) 4 Adjust the volume of the main unit 5 Open or close the disc tray (> 22) 6 Disc tray 7 SD card slot (> 22) 8 [BT730] [BT330] Connect Auto speaker setup microphone 8 9 10 11 12 13 9 Display (FL display) ≥ "SRD" (SURROUND) lights when sound is output to the surround speakers. (For the U.S.A. and Canada) ≥ The display is turned off when the volume is adjusted to "0". (> 37) 10 Remote control signal sensor Distance: Within approx. 7 m (23 ft.) Angle: Approx. 20o up and down, 30o left and right 11 Select the source (> 23) 12 Stop (> 25) 13 Start play (> 25) ∫ If the front cover comes off 1 Hold rear side of main unit by one hand and match up left or right side protruding hook on the cover first with the corresponding slot on the unit. 2 Push the hook firmly towards the unit until it clicks into place. Then push the succeeding hooks one by one until all have clicked into place. 3 Check that the cover now moves correctly. ≥ If it does not, remove it and repeat the above procedure. Main unit (Rear) e.g., [BT730] VOLT ADJ 12 1ニ 2 3 110 127V 220 240V 67 8 4 5 + AC IN 6 55 22 11 6 6 R3 L SUBWOOFER CENTER FRONT DDIIGGIITTAL AUDIIOO IINN (10BASE-T/100BASE-TX) AV OUT OOPPTICAALL L 1 2 R WWIRELEESSSS LAN RÉLSLAEAANUNLOCAL (ARC) VIDEO OUT AUX FM ANT (75 ) DIGITAL TRANSMITTER 9 1 AC IN terminal (> 18) * (For units with PX printed on the packaging) The terminal is not polarized. 2 Speaker terminals (> 13) 3 Cooling fan 4 [BT730] [BT330] [BT230] USB port for optional wireless adaptor (> 17) 5 HDMI AV OUT terminal (> 15) 6 FM radio antenna terminal (> 16) 10 11 7 DIGITAL AUDIO IN terminals (> 14 , 15) Terminal 1 is designated for connection with the TV. Terminal 2 can be used with equipment other than the STB. 8 [BT730] [BT330] [BT230] Digital transmitter dock 9 LAN port (> 17) 10 VIDEO OUT terminal (> 14) 11 AUX terminal (> 14) (For units with PX printed on the packaging) 12 AC Voltage selector (> 18) (For the U.S.A. and Canada) Saving energy This unit is designed to conserve its power consumption and save energy. ≥ This unit will automatically turn to standby mode after 30 minutes if it is inactive. VQT2M13 7