Panasonic WV-CP500 Operating Instructions - Page 24

Configure the settings relating to the alarm output terminal Select the alarm output operation. Follow the procedure below. "SYSTEM SETUP" screen **SYSTEM SETUP** SYNC INT ALARM IN/OUT PRIVACY ZONE OFF STABILIZER OFF EL-ZOOM OFF "ALARM IN/OUT" screen **ALARM IN/OUT** ALARM IN OFF ALARM OUT OFF RET TOP END RET TOP END Step 1 Move the cursor to "ALARM IN/OUT" and press the setting button. → The "ALARM IN/OUT" screen appears. Step 2 Move the cursor to "ALARM OUT" and select the alarm output terminal operation from the following. OFF (default): Does not perform terminal output. ALARM: The alarm output will be performed upon a i-VMD detection. The alarm output will also be performed when receiving an alarm input while operation with setting "ALARM" for "ALARM IN". BW: Activates the output terminal while an image is displayed in the black and white mode. 12. Privacy zone setting [PRIVACY ZONE] When undesired portions in the camera shooting area (on the screen) exist, those portions (privacy zone) are hidden. Up to 8 portions can be specified for the privacy zone. ON (1): Grays the zone. ON (2): Mosaics the zone. OFF (default): Displays the zone normally. Follow the procedure below. Note: • The privacy zone function is disabled at initializing the unit, i.e. right after turning on the power. "SYSTEM SETUP" screen Zone setting screen **SYSTEM SETUP** SYNC INT ALARM IN/OUT PRIVACY ZONE ON(1) STABILIZER OFF EL-ZOOM OFF **ZONE NUMBER 1 /8** POSITION PUSH SW UPPER LEFT RET TOP END DEL RET TOP END Step 1 Move the cursor to "PRIVACY ZONE", select "ON (1)" or "ON (2)", and press the setting button. → The zone setting screen appears. 24