Pfaff Tiptronic 1151 Owner's Manual - Page 34

t tiptrOniC Controls of the electronic system Needle positions "up" and "down" After sewing the needle is always retained at its "up' position. When you press the "needle down" button, indicator light N lights up and the needle remains down in the fabric (for sewing corners and turning the fabric) whenever sewing is interrupted. When you press the button again, the indicator light goes out, the needle moves upwards and is retained in its "up" position whenever the machine stops. The button can be pressed during sewing. Electronic top speed selection By pressing the "sew slow" button, the SsAtcuIonpipatnpdme.gteihWecsdpepaahotecostweeaarnadnmenlriyyogbeoofhesutftyipvmtgopehauoerereeirdeesis.nmdnsedoaetafihcdtcfihalwsaeitnnioblrdelrue. mltcTtithagohaenhneitnmbfsa0uegaltlachlhiihpeganilih,nvetetesrhde. Basting Press the basting stitch button. The green indicator lamp P lights up. Drop the machine feed (page 44) and screw on the darning foot (page 39). Place the fabric under the sewing foot. Each time you press and release the foot pedal the machine sews one stitch. Move the fabric under the sewing foot until the length of stitch required is obtained, then holding the fabric in this position, press down the foot pedal and release it again. Repeat this operation for each basting stitch. When you have finished basting move your foot from the pedal and press basting stitch button again. The green indicator lamp P goes out. Push the dropfeed control to the left again. Close free arm cover 121. Electronic bobbin thread monitor The red signal lamp of bobbin thread monitor Ill starts to flash when the bobbin thread is running out. The lamp goes out when a full bobbin is inserted and sewing continues. Important: Free arm cover 121 must be kept closed. 31