Pioneer 4350HD Owner's Manual - Page 59

Enjoying through External Equipment 12 English Connecting the VCR controller Connect the supplied VCR controller to the Media Receiver. This allows you to preset digital TV programs for recording; see page 48. When the specified time comes, the system in the standby mode is automatically switched on and the specified TV program is recorded using the connected VCR or DVD recorder. • Make sure to leave the VCR power on when presetting TV programs for recording with the VCR controller. • Be sure to firmly connect the VCR controller to the VCR control terminal on the rear of the Media Receiver. If you have mistakenly connected it to the CONTROL IN or CONTROL OUT terminal, remote control or other operations may be disabled. Media Receiver (rear view) IN OUT VCR CONTROL CONTROL IN ANTENNA B ANTENNA/ CABLE A IN Cable CARD S-VIDEO INPUT 2 VIDEO R-AUDIO-L DIGITAL O OPTICA (TS) S400 VIDEO INPUT 1 COMPON R-AUDIO-L Y CB/ SERVICE ONLY OUT MONITOR OUT S-VIDEO VIDEO R-AUDIO-L S-VIDEO R-AUDIO-L IINNPUTT 33 Y CB/ (Once you have positioned the VCR controller, secure with the supplied tape.) VCR CONTROL Position the light emitting section on the VCR controller cable so that it faces the VCR. VCR or DVD recorder Remote control sensor Use the following procedure to set the manufacture of the recording equipment: 1 Press HOME MENU. 2 Select "Tuner Setup". ( / then ENTER) 3 Select "Recorder Setup". ( / then ENTER) 4 Select "VCR Setup". ( / then ENTER) 5 Select the manufacture of the recording equipment. ( / then ENTER) Recorder Setup VCR Setup VCR Setup • XXXXX XXXXX XXXXX xxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxx Home Menu Exit • The screen for recording test appears. 6 Check that the power to the recording equipment is on, and insert tape into the slot. • Insert tape you think it all right to erase its contents. The contents will be erased because Rec and Stop codes are output in the test. • Check that the light emitting section on the VCR controller cable faces the recording equipment. 7 Press A to execute recording test. • If the recording equipment fails to start and stop recording, check and change the specified recording equipment manufacture. 8 Press A to select "Yes, Store Setting". 9 Press HOME MENU to exit the menu. . • Even if you correctly specify the manufacture of the recording equipment, control of some models may be disabled. • Perform the recording test when the recording equipment is not in recording standby or is not recording. • The recording test takes approximately 10 seconds. • The PIONEER has been set as the factory default. 59 En