Pioneer AVIC Z3 Owner's Manual - Page 175
Appendix - install manual
UPC - 012562888613
View all Pioneer AVIC Z3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
Appendix Appendix Appendix The quality of signals from the GPS Check the GPS signal reception and the posi- You cannot position your vehicle satellites is poor, causing reduced tion of the GPS antenna if necessary, or con- on the map or the positioning positioning accuracy. Such a loss of tinue driving until reception improves. Keep error is large. signal quality may happen for the the antenna clear. (Page 90) following reasons: • If a vehicle phone or cellular phone is used near the GPS anten- na, GPS reception may be lost tem- porarily. • Do not cover the GPS antenna with spray paint or vehicle wax, be- cause this may block the reception of GPS signals. Snow buildup can also degrade the signals. Signals from the vehicle's speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed erly. the system. The navigation system may not be mounted securely in your vehicle. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. Your vehicle is operating in Simple hybrid mode. Connect the speed signal input (pink lead wire) of the power cable correctly, and reset the 3D Hybrid Sensor memory ([Learning Status]). The navigation system is installed with an extreme angle exceeding the limitation of the installation angle. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to "Installation Manual" and [Installation Angle Setup].) (Page 92) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) The map continually reorients it- The traveling direction is always set Touch on the screen and change the map self. to Heading Up. display. The daylight display is used even when the vehicle lights are on. [Day] is selected to [Day/Night Dis- Check [Day/Night Display] setting and make play]. sure [Automatic] is selected. (Page 50) The orange/white lead is not connected. Check the connection. The display is very dim. The vehicle's light is turned ON, and Read about [Day/Night Display] setting and, [Automatic] is selected on [Day/ if desired, select [Day]. (Page 50) Night Display]. The vehicle cabin temperature is ex- A Liquid Crystal Display (LCD) is used, and tremely low. such displays tend to darken when cold. Wait for the vehicle to warm up. Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 153) Display tilt is not at the proper set- Press and hold EJECT button to adjust the tilt. ting. En 175