Pioneer PDP-42A3HD Owner's Manual - Page 15
Preparation - power supply
View all Pioneer PDP-42A3HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Preparation 05 English Preparing the remote control unit Inserting batteries 1 Open the battery cover. 2 Insert the supplied two AAA (1.5 V) size batteries. Cautions regarding batteries • The remote control unit cannot operate the system if the batteries in the unit are empty. When this happens, replace the batteries with new ones. • Do not use manganese batteries. When you replace the batteries, use alkaline ones. • Do not mix batteries of different types. Different types of batteries have different characteristics. • Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries. • Do not leave dead batteries in the remote control unit; chemical leakage will occur. If you find any chemical leakage, wipe thoroughly with a cloth. • The batteries supplied with this product may have a shorter life expectancy due to storage conditions. • If you will not use the remote control unit for an extended period of time, remove the batteries from it. • The battery polarities must correspond with the (+) and (-) indicators in the battery compartment. 3 Close the battery cover. • WHEN DISPOSING OF USED BATTERIES, BE SURE TO COMPLY WITH GOVERNMENT REGULATIONS AND ENVIRONMENTAL PROTECTION GUIDELINES THAT APPLY IN YOUR COUNTRY OR AREA. Allowed operation range of the remote control unit Operate the remote control unit while pointing it toward the remote control sensor located at the bottom center of the front panel of the Plasma Display. The distance from the remote control sensor must be within 7 m (23 feet) and the angle relative to the sensor must be within 30 degrees in the right or left direction. POWER S TA N D B Y DTV TV VCR DVD HDMI STA/ONNDBY 30° 7 m (23 feet) Remote control 30° sensor 15 En